Intel US15W user manual Power Up

Quick Start

Step 3: Connect the Back Light Inverter (BLI) to the Samsung panel and LVDS cable.

Step 4: In the Firmware Configuration Menu, go to: Chipset -> North Bridge Configuration -> Boot Display Configuration -> Flat Panel Type to 1024x768 Samsung 15 inch (381.00 mm).

5.3Power Up

Complete the following steps to operate the reference board.

1.Place a DDR2 SO-DIMM in memory socket J6D1.

2.Install or verify the configuration jumpers as shown in Section 4.3.1.

3.Verify presence of RTC battery in Battery Holder at XBT5H1.

4.Plug in an ATX power supply into connectors J3J2 and J1J1; the connectors are keyed and will only fit in one position.

5.Connect a hard drive to connector J4J3 using a PATA cable (red stripe toward pin 1). Connect ATX power to hard drive.

6.Connect a PS/2 keyboard to connector J1A2 (bottom)

7.Connect a PS/2 mouse to connector J1A2 (top)

Note: You can reverse the connections of the keyboard and mouse.

8.If internal graphics are not used, plug a PCI Express* Graphics card in the PCI-E x1 slot J7C1 and connect a monitor to the card.

User’s Manual 43

Document Number: 320264