Intel ZT 4807 Cables

A. Specifications

Cables

Intel recommends the following cables for interfacing to the ZT 4807.

For proper operation, Intel recommends 80-conductor IDE cables for external IDE

connection. If the external IDE device is configured in a master/slave combination with an

on-board IDE device (CompactFlash or processor board mounted hard disk) a custom 80-

conductor IDE cable must be used. Industry standard 80-conductor IDE cables do not

connect PDIAG to the host connector. This causes BIOS drive detection and configuration

errors when a master/slave pair exists across the interface. An 80-conductor IDE cable for

use with the ZT 4807 is available as an accessory from Intel as part number ZT 90250.

An IDE/floppy drive power cable (Intel part number A86460-001) is shipped with the

ZT 4807. This is a 20" Y cable with a 4-pin female D-shell power connector wired to a 4-pin

female mini-plug power connector and a second 4-pin female D-shell power connector. Use

this cable to connect from ZT 4807 output power connector J9 to a floppy drive power input

connector and/or an IDE device power input connector.

Using the ZT 4807 Keyboard/Mouse connector (J15) for both PS/2 keyboard and PS/2

mouse connection requires use of a PC keyboard/mouse Y splitter cable, such as the IBM

ThinkPad Laptop Y Cable. This cable (P/N BC00210) may be obtained from Black Box

Corporation. Contact Black Box at (724) 746-5500, or visit their website at

http://www.blackbox.com. This cable can also be ordered as an accessory from Intel as

ZT 90249.