USER’S GUIDE

Selecting an Address

Changing

the

Keyboard

Address

The address on which your keyboard and receiver communicate is pre-set at the factory. The factory setting is address 1. In most situations this will never need adjustment. However, if you are operating several RF devices in close proximity, or there are interfering sources, you may need to change the address from the factory setting. We recommend that you first try the system out to be sure that you need to change addresses. There are 8 possible addresses to choose from. The 8 addresses are selected thru 4 switches. Both the keyboard and receiver must be set to the same address.

1.Open the battery door on the backside of the key- board and remove the batteries. (See “Installing the Keyboard Batteries” section on the previous

page). Notice the cutout hole in the center of the battery compart- ment, visible once the batteries are removed.

2.Use a small pointed tool (such as a pencil) to set the switches that are located inside the cutout hole. Address selection is made per the chart below

(which is labeled inside the battery door cover).

!