Chapter 2 — Configuring the PB50
4From the host PC, check the wireless settings.
If you have an IPL version of the printer, send these commands to the PB50:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP1<ETX>
<STX><SI>wt,WEP2<ETX>
<STX><SI>wt,WEP3<ETX>
<STX><SI>wt,WEP4<ETX>
<STX><SI>wt,AUTH<ETX>
<STX><SI>wt,WPA<ETX>
<STX><SI>wt,WPA2<ETX> <STX><SI>wt,WPA_PSK<ETX> <STX><SI>wt,ROAM<ETX> <STX><SI>wt,PWR_MODE<ETX> <STX><SI>wt,CHANNEL<ETX> <STX><SI>wt,AP_MAC<ETX> <STX><SI>wt,SIGNAL<ETX> <STX><SI>wt,SPEED<ETX> <STX><SI>wt,ACTIVE<ETX>
If you have a Fingerprint version of the printer, send this command to the PB50:
setup write "wlan","uart1:"
5Set up the PB50 to use the correct SSID and authentication modes. See one of the following procedures to configure wireless printing on your IPL or Fingerprint printer.
6If you are going to use certificates for validation, transfer the certificate to the printer. The printer can accept .pfx, .pem, and
.der certificates.
7Verify that the PB50 is connected to the access point and make sure it has an IP address allocated to it.
Understanding the 802.11 Radio Icons
IconDescription
Excellent signal
Strong signal
Good signal
30 | PB50 Mobile Label and Receipt Printer User’s Guide |
