Intermec PF4I, PX4I, PF2i, PF4i Compact Industrial, PM4i, PX6i Step-by-Step Instructions

4 EasyLAN Wireless Interface Kit Installation Instructions

Chapter 2 — Physical Installation

Step-by-Step Instructions

Switch oﬀ the printer and disconnect the power cord.

Disconnect all communication cables.

Remove the cover over the electronics compartment, as described on

the pages ahead.

e electronic compartment contains wires and

components with dangerous voltage (up to 380V). Make

sure that the printer is switched oﬀ and the power cord is

disconnected before the left-hand cover is removed.

EasyCoder PF2/4i Printers

Open the right-hand door.

Using a #T20 Torx screwdriver, remove the three screws and lift the

cover up so it disengages the bottom plate.

Swing out the rear part of the cover so you can disconnect the console

cable from the CPU board.

Put the cover aside on a soft cloth or similar to avoid scratches.

Contents

Main Page Page Page Contents 1 2 3 4 5 6 Page Before You Begin Safety Information Global Services and Support Warranty Information Web Support Telephone Support Who Should Read This Manual Related Documents Page Page About These Instructions Printer Firmware Installation Kit 2 Step-by-Step Instructions EasyCoder PF2/4i Printers Page Page Page EasyCoder PM4i Printers Page Page EasyCoder PX4/6i Printers Page Page Page Page Setting up Network Parameters Establishing Serial Communications Setup with CompactFlash (Fingerprint only) User and Password 4 Setting Up Wireless Communications General Display Current User Changing User Changing Passwords Active Page SSID (Network Name) WEP 802.11 Authentication WPA Roaming Bias 802.1x Supported EAP Types 802.1x Settings Using Certicates Examples Reading Other Wireless Connection Variables Active Channel Access Point Information Signal Strength Speed Region (a.k.a. Regulatory Domain) Reading Wireless Connection Setup Setting Up Network Parameters New Line IP Selection Method IP Address Subnet Mask Finishing the Setup Page 5 Setting Up Wireless Communications General Display Current User Changing User Changing Passwords Active SSID (Network Name) WEP 802.11 Authentication WPA Roaming Bias 802.1x Supported EAP Types 802.1x Settings Using Certicates Examples Reading Other Wireless Connection Variables Active Channel Access Point Information Signal Strength Speed Region (a.k.a. Regulatory Domain) Finishing the Wireless Setup Setting Up Network Parameters Setting the IP Selection Method Read-only Read-only Read-only Read-only Read-only These menus will only be displayed when an optional EasyLAN interface board is installed. EasyLAN Wireless Interface Kit Installation Instructions 51 Reading the IP Address 1 After having selected the method for assigning the IP address, the display shows: NETWORK: IP ADDRESS Example of the network setup when an automatic IP selection method is used. IP ADDRESS: 192.168.1.79 Reading the Netmask, Default Router, and Name Server Using ARPnPING to set an IP Address (Windows) Page Setting Network Parameters in Manual Mode Page Page Page Page Page *1-960610-04*

Intermec Step-by-Step Instructions

Models: PF4I PX4I PF2i PF4i Compact Industrial PM4i PX6i

EasyCoder PF2/4i Printers