Intermec PF4I, PX4I, PF2i, PF4i Compact Industrial, PM4i, PX6i - page 17

EasyLAN Wireless Interface Kit Installation Instructions 5

Chapter 2 — Physical Installation

Remove any optional interface board or blind cover plate ﬁtted on the

rear plate.

Remove any present EasyLAN Ethernet interface installed in the

printer including cables etc.

Remove the present rear plate like this:

Loosen but do not remove the two #T20 Torx screws that hold

the rear plate and the #T20 Torx screw that holds the rear bottom

corner of the CPU board.

Carefully manipulate the rear plate out of the groove in the chassis.

Allow the CPU board to ﬂex a little to be able to get the connectors

out of their slots.

Install the rear plate included in the kit in reverse order and tighten all

three screws.

Reinstall any optional interface board or blind cover plate previously

removed.

Connect the antenna cable to the radio module, which is factory-

ﬁtted on the EasyLAN adapter board, as illustrated below. Support

the upper edge of the radio module with a ﬁnger while connecting the

cable.

Remove the #T20 Torx screw that holds the upper/front part of the

CPU board to the power supply unit and replace it with the hexagonal

spacer included in the kit. Keep the screw.

8

9

10

a

b

11

12

13

14

Radio module

Adapter board

Connect antenna

cable here

Contents

Main Page Page Page Contents 1 2 3 4 5 6 Page Before You Begin Safety Information Global Services and Support Warranty Information Web Support Telephone Support Who Should Read This Manual Related Documents Page Page About These Instructions Printer Firmware Installation Kit 2 Step-by-Step Instructions EasyCoder PF2/4i Printers Page Page Page EasyCoder PM4i Printers Page Page EasyCoder PX4/6i Printers Page Page Page Page Setting up Network Parameters Establishing Serial Communications Setup with CompactFlash (Fingerprint only) User and Password 4 Setting Up Wireless Communications General Display Current User Changing User Changing Passwords Active Page SSID (Network Name) WEP 802.11 Authentication WPA Roaming Bias 802.1x Supported EAP Types 802.1x Settings Using Certicates Examples Reading Other Wireless Connection Variables Active Channel Access Point Information Signal Strength Speed Region (a.k.a. Regulatory Domain) Reading Wireless Connection Setup Setting Up Network Parameters New Line IP Selection Method IP Address Subnet Mask Finishing the Setup Page 5 Setting Up Wireless Communications General Display Current User Changing User Changing Passwords Active SSID (Network Name) WEP 802.11 Authentication WPA Roaming Bias 802.1x Supported EAP Types 802.1x Settings Using Certicates Examples Reading Other Wireless Connection Variables Active Channel Access Point Information Signal Strength Speed Region (a.k.a. Regulatory Domain) Finishing the Wireless Setup Setting Up Network Parameters Setting the IP Selection Method Read-only Read-only Read-only Read-only Read-only These menus will only be displayed when an optional EasyLAN interface board is installed. EasyLAN Wireless Interface Kit Installation Instructions 51 Reading the IP Address 1 After having selected the method for assigning the IP address, the display shows: NETWORK: IP ADDRESS Example of the network setup when an automatic IP selection method is used. IP ADDRESS: 192.168.1.79 Reading the Netmask, Default Router, and Name Server Using ARPnPING to set an IP Address (Windows) Page Setting Network Parameters in Manual Mode Page Page Page Page Page *1-960610-04*