EasyLAN Wireless Interface Kit Installation Instructions 23
Chapter 4 — Setup in Fingerprint
rebooting the printer is the “ACTIVE” setting. Setting this to anything
other than a “0” will cause the current settings to be activated. Reading
the ACTIVE setting will indicate whether the current settings are being
used or not. 0 indicates that the current settings are not active (changes
have been made since startup or last non-zero setting of ACTIVE). 1
indicates that the settings are being used. ACTIVE cannot be set to 0
explicitly (but is implicitly set to 0 by changing another setting). Any
changes made on the web page(s) will be activated when the user submits
the form (given that the settings are correctly entered).
In Fingerprint, there are two sections with an “ACTIVE” setting: “wlan”
for wireless LAN settings, and "8021x" for IEEE 802.1x settings.
Setting ACTIVE to “1” in either section will cause the settings in both
sections to become active - given that ACTIVE was "0" in both sections.
Note: Both sections are controlled by the “setup wlan”
restrictions.
SETUP "wlan","ACTIVE","1" activates the current settings in the
“wlan” section and any changes made in the “8021x” section (forcing a
re-association).
SETUP "8021x","ACTIVE","1" activates the current settings in the
“8021x” section and any changes made in the “wlan” section (forcing a
re-association).
SETUP GET/WRITE for “ACTIVE” will get 1 if the current settings
are in use, 0 if a setting has been changed.