Intermec PF4I, PX4I, PF2i, PF4i Compact Industrial, PM4i, PX6i Finishing the Wireless Setup

EasyLAN Wireless Interface Kit Installation Instructions 49

Chapter 5 — Setup in IPL

<STX><SI>wt,SPEED<ETX>

Transmits network speed.

Region (a.k.a. Regulatory Domain)

Some countries and regulatory authorities only allow the use of a subset

of the 14 channels speciﬁed in the 802.11b/g standard. To make the

product world conﬁgurable the setup variable “.REGION” is used.

e region can only be set by personnel authorized by Intermec. If the

wrong region/domain is set, please contact your Intermec representative

immediately. Continued use of the EasyLAN Wireless network interface

with an incorrect REGION setting may be in violation of applicable

laws.

e region setting will not be reset to default, even if a factory default

upgrade is performed.

e following regulatory domains are implemented:

Regulatory Domains

Value Countries Allowed Channels

FCC (or USA) U.S.A 1-11 (default)

IC (or Canada) Canada 1-11

ETSI (or EU) EU countries1 + Iceland,

Liechtenstein, Norway, and

Switzerland

1-13

MKK (or Japan) Japan 1-14

1/. Certain restrictions apply to outdoor use in France.

<STX><SI>wt,.REGION<ETX>

Transmits the active region.

Finishing the Wireless Setup

You can now disconnect the printer from the PC. You still need to assign

an IP address, subnet mask, default router, and name server. is can be

done via the printer’s display and keyboard (provided the server supports

DHCP or BOOTP). If not, you must rely on wireless communication

and use the ARP’n’PING method, which require that there is a working

wireless LAN and the printer is inside the coverage area of an access

point.

Contents

Main Page Page Page Contents 1 2 3 4 5 6 Page Before You Begin Safety Information Global Services and Support Warranty Information Web Support Telephone Support Who Should Read This Manual Related Documents Page Page About These Instructions Printer Firmware Installation Kit 2 Step-by-Step Instructions EasyCoder PF2/4i Printers Page Page Page EasyCoder PM4i Printers Page Page EasyCoder PX4/6i Printers Page Page Page Page Setting up Network Parameters Establishing Serial Communications Setup with CompactFlash (Fingerprint only) User and Password 4 Setting Up Wireless Communications General Display Current User Changing User Changing Passwords Active Page SSID (Network Name) WEP 802.11 Authentication WPA Roaming Bias 802.1x Supported EAP Types 802.1x Settings Using Certicates Examples Reading Other Wireless Connection Variables Active Channel Access Point Information Signal Strength Speed Region (a.k.a. Regulatory Domain) Reading Wireless Connection Setup Setting Up Network Parameters New Line IP Selection Method IP Address Subnet Mask Finishing the Setup Page 5 Setting Up Wireless Communications General Display Current User Changing User Changing Passwords Active SSID (Network Name) WEP 802.11 Authentication WPA Roaming Bias 802.1x Supported EAP Types 802.1x Settings Using Certicates Examples Reading Other Wireless Connection Variables Active Channel Access Point Information Signal Strength Speed Region (a.k.a. Regulatory Domain) Finishing the Wireless Setup Setting Up Network Parameters Setting the IP Selection Method Read-only Read-only Read-only Read-only Read-only These menus will only be displayed when an optional EasyLAN interface board is installed. EasyLAN Wireless Interface Kit Installation Instructions 51 Reading the IP Address 1 After having selected the method for assigning the IP address, the display shows: NETWORK: IP ADDRESS Example of the network setup when an automatic IP selection method is used. IP ADDRESS: 192.168.1.79 Reading the Netmask, Default Router, and Name Server Using ARPnPING to set an IP Address (Windows) Page Setting Network Parameters in Manual Mode Page Page Page Page Page *1-960610-04*