Intermec PRO 128 manual What YOU see ON-SCREEN, What You See On-Screen

USING THE TRACKER UNIT

WHAT YOU SEE ON-SCREEN

If you are using the Tracker unit in Simulator when no transducer is con- nected, any selected options are lost when the unit is powered off. The Tracker unit will return to Factory Settings, or options selected when last used with a transducer, if no transducer is connected.

IMPORTANT: A transducer must be connected to the Tracker unit in order to retain user settings selected when in simulator mode. If no transducer is detected, the unit defaults to pre-selected options when powered off.

What You See On-Screen

Your Tracker unit uses a 128 V x 64 H matrix FSTN LCD display. This display provides outstanding viewability in all light conditions over a wide range of temperatures.

At initial power-up, the Tracker unit uses settings that were set at the factory. After initial use, the Tracker unit will remember the settings you enter.

There are several elements on-screen that are common to all modes of opera- tion.

Figure A

Temperature/Speed. The initial screen layout takes one of two basic forms depending on whether the optional Temp/Speed accessory is installed. Figure A shows the default view when the Temp/Speed accessory is installed. Figure B shows the default view when the Temp/Speed accessory is not installed.

Depth. The digital depth number shows the water depth directly beneath the transducer location.

Depth Range. The depth range is shown to the right of the screen. The upper number is 0 indicating the surface of the water. The lower number is one of the nine depth ranges available that best match the depth of the water. As the

4