B.MODULE
Your module has been designed to be user- servicable, assuming a basic knowledge of the operation of electrical devices. This section has been written to guide the user step by step, and in layman’s terms, through the dismantling and servicing of the module. Before attempting to service your module, read the appropriate Module Repair Procedures (found elsewhere in this section) thoroughly. If you do not understand the Repair Procedures or prefer not to service your module yourself, or if your warranty is still in effect, please contact our Customer Service Department for the factory authorized service agency nearest you.
The lead cord plug configuration designates whether your module uses a 15 or 20 amp service. Refer to the illustration below to identify the two different plugs.
15 AMP PLUG | 20 AMP PLUG |
|
|
HM15LWHM2000/FL2000
MODULEMODULE
CAUTION: IT IS IMPORTANT THAT ALL SAFETY PRECAUTIONS PERTAINING TO THE SERVICING OF ELECTRICAL DEVICES BE OBSERVED AT ALL TIMES.
1.Dismantle your module for servicing per the following instructions.
NOTE: To replace the Thermostat and Humidity Knobs, or water pan/water bottle, it is not necessary to dismantle the module.
a. Make sure the lead cord is not plugged into an outlet. Be certain that the module and any water in the water pan has cooled to a temperature safe for handling.
b. Remove module by lifting the front enough
to clear the detent, then pull the module from the cabinet, grasping it with both hands as it clears the cabinet. The cord should slip through the clearance hole in the back of the cabinet.
c. Remove the water pan/water bottle and drain water.
d. Unfasten the electrical cover by removing the three screws along the front of the module and the two screws along each edge of the module. Retain this hardware for
e. Open the module by raising the component chassis from the electrical cover and placing the chassis top down on a dry,
2.Refer to the appropriate Module Replacement Parts Diagram to identify the internal components. Determine malfunctioning component(s) by electrical diagnostic procedures.
3.After servicing, be sure to verify the routing of each wire with the wiring schematic before installing electrical cover and connecting module to power source. Be sure that the thermostat sensor tube does not contact any electrical connections.
4.Assemble components using retained hardware, making sure that no wires are pinched between the cover and the component chassis.
5.Install water pan/water bottle. Then, feed cord through clearance hole in cabinet and slide module into cabinet.
10
