(110) MODEL 634 FILTER PUMP ENGLISH 7.5” X 10.5” PANTONE 295U 01/31/2007

110

STRAINER & PLUNGER VALVE SET-UP

The Krystal Clear™ filter pump assembly includes two strainer-control mechanisms that are to be installed in the pool liner’s two pre-cut holes. The strainer grid prevents large objects from jamming and/or damaging the filter pump and the plunger valve assembly prevents water from flowing into the filter pump while the filter cartridge is being placed or cleaned. For Easy Set™ Pools, install the strainer and plunger valve before inflating the pool liner top ring.

SET-UP INSTRUCTIONS

1.

Grasp the strainer and plunger valve

2.

mechanism.

In a counter-clockwise motion unscrew

 

plunger valve union from the threaded

 

strainer connector (14). Be careful not

 

to lose the step rubber washer (11).

 

Place the plunger valve on the ground

3.

in a safe place (see drawing 1).

In a counter-clockwise motion unscrew

 

the strainer nut (12) from the threaded

 

connector (14). Leave the flat

4.

washer (13) on the connector (14).

From the inside of the pool liner insert

 

the connector (14) into one of the

 

pre-cut holes with the washer remaining

 

on the connector to be placed against

 

the inside of the liner wall.

5.

With the flat side of the strainer nut (12)

 

facing the outside wall of the liner in a

 

clockwise motion screw the strainer

 

nut (12) back onto the threaded

 

connector (14) (see drawing 2). Before

 

assembly, lubricate the threads with a

 

petroleum jelly.

6.

Finger tighten the strainer grid (15) and

 

the strainer nut (12) onto the threaded

7.

connector (14).

Grasp the plunger valve assembly. Make

 

sure the step washer (11) is in place.

1

2

1

INSIDE 2

LINER WALL

12 13 14 15

3

1

2

8. In a clockwise motion screw the plunger

1

4.1

 

valve union back onto the threaded

9.

connector (14) (see drawing 3).

Examine the plunger valve to see if the

 

handle is pushed fully down to the "0/1"

 

position. If not, then grasp the handle at

 

the top and push down turning the

 

handle in a clockwise direction until the

 

plastic protruding notch anchors in

 

the "0/1" position. This will prevent

 

water from flowing out during filling

10.

(see drawings 4.1 & 4.2).

Repeat steps 1 through 9 for the 2nd

11.

liner pre-cut hole.

The pool liner is now ready to fill with

 

water. Consult the above-ground-pool

 

owner’s manual for filling instructions.

INSIDE

2 LINER WALL

4.2

SAVE THESE INSTRUCTIONS

Page 7