Related Error Messages
The Solaris configuration administration utility, cfgadm, reports an error when it is used on systems where the Sun StorEdge Availability Suite software is installed. The error occurs because a process does not suspend properly so that the cfgadm operation can proceed. The error message has the following format:
cfgadm: Hardware specific failure <operation> failed: could not suspend user process <process_id>
You must stop the process manually, perform the cfgadm operation, and then start the process again. Use the following commands to accomplish this:
1. Quiesce I/O to the sets, using the following series of commands:
/etc/init.d/rdc stop /etc/init.d/ii stop /etc/init.d/sv stop /etc/init.d/scm stop
2.Issue the cfgadm command.
3.Start I/O to the sets, using the following series of commands:
/etc/init.d/scm start /etc/init.d/sv start /etc/init.d/ii start /etc/init.d/rdc start /etc/init.d/rdcfinish start
42 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide • December 2003
