TABLE
Error Message | From | Meaning |
Bitmap reconfig failed %s:%s | Kernel | A request to reconfigure the bitmap on the local host |
|
| has failed. This can happen for two reasons: |
|
| • The old bitmap cannot be read from to obtain |
|
| needed information. |
|
| • The new bitmap cannot be reserved because the |
|
| volume is not accessible or is already in use. Verify |
|
| that the new bitmap volume is accessible and is not |
|
| already in use. |
bitmap <vol> is already in use by | RM | The volume requested as a bitmap for the remote |
StorEdge Network Data Replicator |
| mirror set is already configured to be used by the |
|
| remote mirror software. |
bitmap <vol> is in use by Instant | RM | The volume requested as a remote mirror bitmap |
Image |
| volume is already configured to be a volume used by |
|
| the |
bitmap <vol> is in use by SCSI | RM | The volume requested as a remote mirror bitmap |
Target Emulation |
| volume is already configured for use by STE (SCSI |
|
| Target Emulation). |
Bitmap volume is already an | PITC | The volume that was specified as the bitmap volume |
overflow volume |
| during an enable operation is already being used by |
|
| another set as an overflow volume. |
Bitmap volume is not a character | PITC | The volume that was specified as the bitmap volume |
device |
| during an enable operation is a block device and not a |
|
| character device. |
bitmap volume name must start with | PITC | The volume that was specified as the bitmap volume |
/dev |
| during an enable or import operation does not start |
|
| with /dev. |
both <phost> and <shost> are local | RM | The set specifies the same host as both primary and |
|
| secondary. The primary and secondary hosts must be |
|
| different. |
Cannot add %s:%s ==> %s:%s to group %s
Cannot change disk queue %s, Must be in logging mode
Can not check volume against mount table
Kernel | The set being added to a group cannot be added. |
| Typically, this happens because the set being added is |
| of a different type (sync or async) than the sets already |
| in the group. |
Kernel | A disk queue cannot be added to or removed from a |
| set if it is not in logging mode. Place the set into |
| logging mode and then attempt to add or remove the |
| disk queue. |
PITC | The iiadm operation attempted to determine whether |
| a volume on the command line belongs to a mounted |
| filesystem . The test for this has failed. |
Chapter 3 Error Messages 21