TABLE
Error Message | From Meaning |
unable to determine hostname: <host>
unable to determine IP addresses for either host <phost> or host <shost>
unable to determine IP addresses for hosts <host1>, <host2>
RM | Could not determine the host name of the system. |
RM | The IP address for either the primary host or the |
| secondary host could not be determined. |
RM | The IP addresses for the host names specified for the |
| primary or secondary hosts could not be determined. |
| Verify that the host names are in the /etc/hosts file. |
unable to determine local hostname PITC | iiadm needed to find out the name of the host it is |
| running on, but was unable to do so. |
unable to determine network information for <host>
unable to determin the current Solaris release: <error>
unable to find disk service, <ctag>: <errno>
Unable to find disk service:%s
Unable to find <group> in configuration storage
Unable to find <shost>:<svol> in configuration storage
unable to find SNDR set <shost>:<svol>: in config
Unable to fork
unable to get maxsets value from kernel
unable to get set status before reconfig operation
Unable to initialize the kernel thread set
RM | Network information for the secondary host could not |
| be determined. Verify the settings in the |
| /etc/nsswitch.conf file. |
RM | Look at rdc_check_release(); |
RM | SunCluster could not find the specified disk service. |
PITC | iiadm could not determine whether a cluster device |
| group is active on the current host. |
RM | Could not find remote mirror group in configuration |
| database while trying to do a diskq operation. |
RM | Could not find remote mirror set in configuration |
| database while trying to do a diskq operation. |
RM | The remote mirror set is not configured while trying to |
| set autosync, for one of the following reasons: |
| • The set could not be found in the configuration. |
| • The set is not configured in the configuration |
| database. |
| Verify that the set is entered properly and matches a |
| set returned by the sndradm |
PITC | iiadm ran out of process space. |
RM | The remote mirror software failed to read the |
| sndr_max_sets value from the |
| /usr/kernel/drv/rdc.conf file. |
RM | The remote mirror software could not get the kernel |
| configuration. |
Kernel | The remote mirror software could not initialize a |
| kernel thread. Verify that the system is not running |
| low on memory. |
38 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide • December 2003