USING THE VENTILATOR TRAY (FIGURE 2)
NOTE: The ventilator tray straps are installed on the ventilator tray before the ventilator tray is shipped.
1.Position all six (6) strap slides on the outside of the ventilator tray.
2.Position the ventilator battery in the front portion of the ventilator tray.
3.Secure the two (2) battery straps around the top of the ventilator battery and clip together.
4.Position the ventilator in the rear portion of the ventilator tray.
5.Secure the four (4) ventilator straps around the top of the ventilator and clip together.
6.Adjust the slides, located in the middle of each strap, up or down to increase or decrease length. See DETAIL “C”.
7.Securely tighten the straps around the battery and ventilator by pulling the ends of the straps through the rear portion of each buckle. See DETAIL “D”.
DETAIL “C”
Strap
Slide
DETAIL “D”
Strap
Rear
Portion
of Buckle
Rear Portion of Ventilator Tray | Ventilator Straps |
Ventilator Straps | Battery Strap |
|
Battery Strap
Slides
Front Portion of Ventilator Tray
FIGURE 2 - USING THE VENTILATOR TRAY
Invacare Corporation | www.invacare.com |
|
|
|
|
USA | Canada |
|
One Invacare Way | 570 Matheson Blvd. E Unit 8 Invacare is a registered trademark of | |
Elyria, Ohio USA | Mississauga Ontario | Invacare Corporation. |
L4Z4G4 Canada | Yes, you can. and Solara jr. are | |
trademarks of Invacare Corporation. | ||
|
| © 2001 Invacare Corporation |
|
| Rev A 03/02 Part No. 1106665 |
