Invacare 1141448 operating instructions Modification for approximately 1-inch of obliquity

Modification for approximately 1-inch of obliquity

NOTE: This modification can be done on either side of the cushion.

1.Determine which side of the cushion needs to be lowered.

2.Remove the cushion from inner and outer covers. Refer to Removing/Installing the Cushion Covers on page 4.

3.On the side of the cushion that needs to be lowered, remove the obliquity insert by pulling on the tab.

4.Align the chamfered edges on the obliquity inserts as shown in DETAIL “B” of FIGURE 5.

5.Put the obliquity insert removed in step 3 onto the obliquity insert that is in place on the cushion as shown in DETAIL “B” of FIGURE 5.

6.Apply pressure along the hook and loop strip. Pull on the tab to make sure that the obliquity inserts are securely in place before installing the covers.

7.Install the cushion into inner and outer covers. Refer to Removing/Installing the Cushion Covers on page 4.

Top of cushion

Tab

Bottom of cushion

Tab Obliquity Inserts

DETAIL “A” - MODIFICATION FOR APPROXIMATELY

½-INCH OF OBLIQUITY

NOTE: This modification can be done on either side of the cushion.

Remove one obliquity insert for ½-inch modification

Hook and loop strip

Bottom of cushion

Tab

Top of cushion

DETAIL “B” - MODIFICATION FOR APPROXIMATELY

1-INCH OF OBLIQUITY

NOTE: This modification can be done on either side of the cushion.

Put the obliquity insert removed in STEP 3 onto the obliquity insert in place on the cushion for 1-inch modification

Bottom of cushion

Hook and loop strip

Align the chamfered edges of the obliquity inserts

Tab

Top of

cushion

FIGURE 5 Modifying the Cushion to Accommodate Obliquity

Part No 1141448 7 InTouch™ Stabilite/Stabilite OM Cushion