11 TRANSPORTING
11 Transporting
WARNING
After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and remove key from ignition. DO NOT lift the scooter by the rear shroud - otherwise damage to the scooter may occur.
11.1 Transporting the Scooter
For this procedure, refer to FIGURE 11.1 on page 52.
Disassembling
1.Turn power off and remove the key from the ignition.
2.Remove the basket.
3.Remove the seat. Refer to Removing/Installing the Seat on page 33.
4.Remove the batteries. Refer to Removing/Installing the Batteries on page 48.
5.Disconnect the main wiring harness connector.
6.Hold the seat post with one hand.
7.With the other hand, push the release lever to the rear of the scooter.
8.Lift the seat post to separate the front frame assembly from the rear frame assembly.
9.Fold tiller down to lowest locked position. Refer to Adjusting the Tiller Angle on page 41.
Invacare® Leo™ Scooter | 52 |
Rear of
Rear Scooter
Frame
Assembly
Main Wiring
Harness
Connector
Front Frame
Curved
Bracket On
Rear Frame
Post
FIGURE 11.1
Seat
Post
Release
Lever
Front
Frame
Assembly
Front of Scooter
Transporting the Scooter
Part No. 1163141
