SECTION 9—POWER ELEVATING LEGRESTS
2G Tarsys®Powered Seating System 106 Part No 1114842
Adjusting the Power Elevating Legrests

Adjusting the Footplate

WARNING
DO NOT remove heel loops without providing some other adequate means of
support, otherwise personal injury may occur.
Adjusting the Footplate Height
NOTE: For this procedure, refer to FIGURE9.2.
NOTE: The following procedure should be performed with the user in the wheelchair.
NOTE: T-nuts ride in the channels of the exterior/interior rails of the power legrests.
1. Loosen, but DO NOT remove, the two interior button screws that secure the footplate
assembly to the T-nuts.
2. Loosen, but DO NOT remove, the two exterior button screws that secure the footplate
assembly to the T-nuts.
3. Loosen, but DO NOT remove, the two button screws that secure the heel loop to the
T-nut s.
4. Slide footplate assembly up or down, until desired height is achieved.
5. While holding footplate assembly in position, tighten all six button screws that were
loosened in STEPS 1-3.
6. Repeat STEPS 1–5 for opposite footplate if necessary.
FIGURE 9.2 Adjusting the Footplate Height
Exterior Rail
Channel
T-Nuts (Not Shown)
Footplate
Assembly
Exterior
Button Screws
Outside View Inside View
Channel
T-Nuts (Not Shown)
Footplate Assembly Interior Button
Screws
Button Screws
for Heel Loop