SECTION 12—HEADREST
2G Tarsys®Powered Seating System 124 Part No 1114842
SECTION 12—HEADREST WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.
Removing/Installing/Adjusting Headrest
NOTE: For this procedure, refer to FIGURE12.1.
Removing
1. Loosen, but DO NOT remove, the thumb screw that secures the headrest to the
headrest mounting bracket.
2. Remove the headrest from the headrest mounting bracket.
Installing
1. Make sure thumb screw is loose.
2. Install the headrest until the headrest stop sits on the headrest mounting bracket.
3. If necessary, adjust the height, depth or direction of the headrest. Refer to Adjusting
Headrest Height on page 125.
FIGURE 12.1 Removing/Installing/Adjusting Headrest
Depth
Adjustment
Offset Fixture
Slide Tube
Socket Screws
Height Adjustment
Thumb Screw
Headrest Mounting Bracket Headrest Stop
Set Screw