SECTION 5—INTERFACE HARDWARE
Part No 1114842 43 2G Tarsys®Powered Seating System
• Rear Pivot Assembly Is Hard To Move - Repeat STEP 3 and STEP 4 until the rear
pivot assembly moves freely.
NOTE: It may be necessary to loosen the socket screws to adjust the linear guides.
6. Torque the socket screws to 75 in-lbs ± 20%.
7. Secure the rear of the tilt actuator to the rear pivot assembly using the shoulder bolt,
two bushings and the locknut. Torque to 23 ft-lbs ± 20%.
8. Install the seat assembly. Refer to Removing/Installing the Seat on page75.
FIGURE 5.2 Removing/Installing the Rear Pivot Assembly - Tilt Only and Tilt/Recline Systems
Locknut
NOTE: Front of tilt actuator shown disassembled
for clarity only. There is no need to remove the
hardware securing the front of the tilt actuator for
this procedure.
Bushings Tilt Actuator
Shoulder Bolt
Clamp Bar
Rear Pivot Assembly
Upper Portion of
Linear Guide
Lower Portion of
Linear Guide
Socket Screw
Access Hole
Seat Bracket