Replacing Arm Pad, Replacing Fastening Strap, Storage

Replacing Arm Pad

NOTE: For this procedure, refer to FIGURE 7.

NOTE: Note the position of the existing arm pad for correct installation of the new arm pad.

1.Slip existing pad off of arm support.

2.Place new cover and pad on arm support.

NOTE: The sides of the cover are on the outside of the arm support, while the ends are tucked in.

Arm

Pad

Arm

Support

NOTE: For this procedure, refer to FIGURE 8.

1. Remove arm pad and cover. Refer to STEP 1 in Replacing Arm Pad on page 5.

NOTE: Note the orientation of the existing arm strap for installation of the new arm strap.

2.	Pull on ring and remove fastening strap
	through the slots in the arm support.
3.	Thread the end, without the ring, of the

Slots

Fastening

new arm strap through slots in the arm

support.

Arm Support

Strap

NOTE: Make sure the hook end is facing down or the arm strap will not secure properly.

4.Reinstall the arm pad and cover. Refer to STEP 2 in Replacing Arm Pad on page 5.

Ring

NOTE: The platform attachment does not require removal to fold the walker.

1.Fold the walker per your walker recommendations.

2.Lower the height of the platform attachments if necessary. Refer to Adjusting Height on page 3.

1.Use a mild soap or detergent to clean the arm pads and dry thoroughly.

2.A light oil may be applied to the hardware to lubricate and aid in preventing rust.

Part No 1141466

Walker Platform Attachment