Invacare 6302G Securing the Tub, Securing Legs To Floor, 4.4Leveling the Tub, Leveling End To End

4 INSTALLATION

4.3 Securing the Tub

￿ WARNINGS

SECURING LEGS TO FLOOR

Protective eye wear MUST be worn when drilling to avoid possible eye injury.

DO NOT adjust height of legs more than 1 inch. The leg will disassemble from leg mounting pad and serious injury may occur.

1.	Set the tub in place.
2.	Ensure the plumbing and electrical hook-ups have been installed.
3.	Mark the locations of the anchor holes, using pre-drilled holes in leg
	mounting pads as a template.

Leg

Lag Bolt

Leg Mounting Pad

Lag Bolt

4.	Move the tub away from the mounting area.
5.	Drill anchor holes in floor. Use jack-drill and carbide bit in concrete
	or a wood bit for wood floors.
6.	Reposition the tub in the mounting area, aligning the holes in the leg
	mounting pads with the holes drilled in STEP 4.

4.4Leveling the Tub

1.Level the tub by adjusting the telescopic legs either up or down, using a wrench, to arrive at the desired height.

2.Check to make sure the tub is level by placing a level on the front and sides of the tub.

3.Repeat STEPS 1 and 2 until the tub is level.

4.Secure the legs to the floor using fasteners appropriate to the floor material and in keeping with local codes.

Anchors

LEVELING SIDE TO SIDE

Level

LEVELING END TO END

Level

Invacare® TheraPure™Supine Whirlpool Tubs 16 Part No. 1167456