Invacare 9153644014, 9153644018 operating instructions Installing Front Rigging Support Brackets

4.Insert the proper (right or left) front rigging support bracket into the seat frame tube until two (2) of the four (4) mounting holes on the front rigging support bracket are aligned with the two (2) mounting holes in the seat frame tube.

CAUTION

Two (2) mounting screws are used to secure the front rigging support bracket to the seat frame tube for any mounting position used.

5.Install the existing mounting screw, coved washers, spacers, washers and locknut that secure front seat support tube to the seat frame tube in the orientation noted in STEP 2. DO NOT tighten locknut at this time.

6.Install the new mounting screw, spacer and locknut (hardware supplied) through the large mounting hole on the seat frame tube. Securely tighten.

NOTE: Make sure that the spacer is aligned with the large mounting hole in the seat frame tube and is properly seated against the front rigging support bracket during and after tightening. Refer to Detail “A” of FIGURE 1.

7.Tighten the locknut securing the front seat tube to the seat frame until it is snug and then turn an extra 1/8-turn. DO NOT over-tighten as this is a pivot joint when folding the seat.

8.Repeat STEPS 1-7 to install the front rigging support bracket on the other side.

Seat Frame Tube		New Mounting
Spacer		Screw
		Locknut
Locknut
		Spacer
Existing Mounting
		Coved Washers
Screw
		Front Rigging
	Spacer	Support
		Bracket
		Front Seat
		Support
		Tube

DETAIL “A”	*Large
	Mounting Hole
	Spacer

*NOTE: Mounting hole arrangement on 16-inch wide seat shown. On the 18-inch wide seat, the mounting hole positions are reversed.

*Small

Mounting Hole

Front Seat

Support Tube

Seat Frame Tube

Mounting Holes on Front Riggings Support Bracket

Front Rigging

Support

Bracket

FIGURE 1 Installing Front Rigging Support Brackets

Installing Front Riggings on the At’m 2 Part No 1130250