Installing/Removing the Front Rigging Assembly
NOTE: For this procedure, refer to FIGURE 2.
Installing
1.Turn the front rigging assembly to the side (open footrest is perpendicular to the wheelchair).
2.Insert the mounting pin on the front rigging assembly into the front rigging support bracket.
3.Rotate the front rigging assembly towards the inside of the wheelchair until it locks into place.
NOTE: The footplate will be facing the inside of the wheelchair when locked in place.
4.Repeat STEPS
5.If necessary, adjust the footrest height. Refer to Adjusting Footrest Height on page 4.
Removing
1.Push the front rigging release lever inward while rotating the front rigging assembly outward.
2.Lift the front rigging assembly out of the front rigging support bracket.
3.Repeat STEPS
| Mounting Pin |
Seat Frame Tube | Front Rigging |
| Assembly |
Inside of | Outside of |
Wheelchair | Wheelchair |
Front Rigging |
|
Release Lever |
|
Front Rigging | Footrest |
Support Bracket |
|
FIGURE 2 Installing/Removing the Front Rigging Assembly
Part No 1130250 | 3 | Installing Front Riggings on the At’m |
