Adjusting Footrest Height
NOTE: For this procedure, refer to FIGURE 3.
1.Remove the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 3.
2.Remove the hex screw and coved spacer.
3.Move the footrest with slide tube up or down on its mounting tube until the desired footrest height is achieved.
4.Install the hex screw and coved spacer through the front rigging upper support and the slide tube. Securely tighten.
5.Install the front rigging assembly. Refer to Installing/Removing the Front Rigging Assembly on page 3.
6.Repeat STEPS
| Front Rigging |
| Upper Support |
Hex Screw |
|
Coved Spacer | Slide Tube |
Footrest
FIGURE 3 Adjusting Footrest Height
Invacare Corporation | www.invacare.com |
|
|
|
|
USA | Canada |
|
One Invacare Way | 570 Matheson Blvd E Unit 8 | Invacare is a registered trademark of |
Elyria, Ohio USA | Mississauga Ontario | Invacare Corporation. |
L4Z 4G4 Canada | Yes, you can. is a trademark of Invacare | |
Corporation | ||
|
| © 2005 Invacare Corporation |
|
| Part No 1130250 |
|
| Rev A - 06/05 |
