ON/OFF diode status display | Invacare Electric wheelchair specification

7.2ON/OFF diode (status display)

INFORMATION

The ON/OFF diode (in key symbol) also serves as status or error message display. For error codes please see chapter "Error codes and diagnostic codes" on page 46.

7.3Battery charger display

•

All diodes illuminated: Full range

Battery charger display

•Only red diodes illuminated:

Reduced range

•Both red diodes flashing:

Very low range

•Only one red diode flashing:

Battery on reserve = Charge batteries straight away

INFORMATION

Protection against total discharge: The electronic system automatically shuts actuation down after a certain travel time on reserve battery and the wheelchair comes to a standstill.

37

Image 37

Invacare Electric wheelchair manual ON/OFF diode status display, Battery charger display

Contents

Invacare Typhoon Deutschland Danmark How can you get in touch with Invacare? Portugal Table of Contents Pushing the wheelchair by hand Adjusting the wheelchair to the users seating postureREM 24 SD Remote Electrical System Care and maintenance Repair Instructions Repairing a flat tyre Dear user IntroductionPage This symbol warns you of danger Important symbols in this manualRequirements Permissable operating conditions Type Classification and Area of Use Indications General Safety Notes Safety NotesPage Page Safety Information on Electromagnetic Interference Safety Information on Driving and Freewheel Mode Page Important if Your Wheelchair is Equipped with a Lifter Safety Information on Wheelchairs with a Lifter More than 15-45 Safety Information on Wheelchairs with Recaro SeatsStandstill Driving Key features Remove the standard armrest in order to side transfer Getting in and out of the wheelchairRemoving the armrest Removing the skirtguard optional to get on Swivel up armrest Getting out of the wheelchair Getting into the wheelchair Before driving for the first time Driving SureStep System Taking ObstaclesStability Lock System Maximum obstacle height Components of the SureStep and the Stability Lock system Safety information when descending obstacles Safety information when ascending obstacles Ascending and descending Correct way to overcome obstaclesRight Wrong Parking and stationary Driving up and down gradients Manually disengaging conventional motors Pushing the wheelchair by handDisengaging motors Re-engaging motors Electrically disengaging GB motors Manually disengaging GB motors emergency disengaging Upper side REM 24 SD RemoteLayout of the remote Controls Displays Rear panel Underside ON/OFF diode status display Battery charger display Activating the immobilizer Activating / deactivating the immobilizerDeactivating the immobilizer Magnetic key What is a Buddy button? Using the Buddy buttons with the remote Will the wheelchair not drive after switching on? Controlling the wheelchair using the remoteCan the electronic system programming be adapted? Page Activating adjustment mode Operating the electric adjustment options Information Selecting and operating the adjustment option Changing back to driving mode Battery discharged. Please charge the battery Error diagnosis Flash Fault Immediate Measure Further Help Code Error codes and diagnostic codes Flash Fault Immediate Measure Further Help Code Recaro seats Adjusting the wheelchair to the users seating postureRecaro Seats Adapting the remote to the length of the user’s arm Adjusting the armrests and the joystick box Setting the height of the remote Setting the height of the armrests Where to find the adjustment screws Setting the width of the armrests Doing the adjustment Manually adjusting the seat tilt Page Adjusting the backrest using the gas pressure spring Manually adjusting the backrestAdjusting angle of the backrest Adjust the backrest using the perforated plate Flex and Contour Seats Please note Speed restriction Lifter Explanation of symbols on lifter warning sticker Electric legrest LegrestsCompletely lowering electrical legrests as dismounting aid Adjusting the angle Prerequisites Adjustable legrest Adjusting the length of the legrest Prerequisites Adjusting the calf plate to the calf width of the user Adjusting the angle of the foot plate Prerequisites Electronics Protection System Electrical System Main fuse What you need to know about batteries BatteriesPage Charging the batteries Charging the batteries After contact with skin Removing and fitting batteriesAfter contact with eyes Removing the batteries Page Page Page Page Releasing the lifter locking mechanism Disposing of dead or damaged batteries correctly Cleaning the vehicle Care and maintenanceDisinfection Side part and armrest Maintenance Jobs Seat and backrest paddingLegrests Tyres Cleaning Maintenance JobsElectronics / Electrical System Repair Instructions Repairing a flat tyre Requirements Removing the wheel Repairing the flat tyre Explosion Hazard Disassembly Page Refurbishment Disposal Charging device Technical Specifications Dimensions Standard Contour Recaro Flex Weight Without lifter With lifter Loading Inspections Performed English