SECTION
Disconnecting the Cylinder from the Compressor
WARNING
NEVER use tools of any kind to connect/disconnect the cylinder and the compressor. Otherwise, severe injury and/or damage may occur.
NOTE: For this procedure, refer to FIGURE 4.4 on page 16.
1.Press the compressor power switch to the Off (O) position.
2.Grasp the cylinder/regulator assembly in the area behind the cylinder gauge.
3.With the other hand, grasp the outer ring (sleeve) of the connector fillport and push DOWN.
4.Lift up on the cylinder/regulator assembly to remove from the connector fillport.
| Cylinder/Regulator |
|
| Assembly | PUSH DOWN |
Cylinder |
|
|
Gauge | Cylinder | Outer Ring |
| (Sleeve) | |
| Fillport | |
Compressor |
| |
|
|
Connector 
Fillport
FIGURE 4.4 Disconnecting the Cylinder from the Compressor
Oxygen Conserving Cylinder | 16 | Part No 1143247 |
