SECTION
SECTION 6—FRONT RIGGINGS
WARNING
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting in or out of the wheelchair, make sure that the footplates on the front riggings are in the upward position or moved out of the way.
Before performing any maintenance, adjustment or service verify that On/Off switch on the joystick is in the Off position.
While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage may result.
Installing/Removing Front Riggings
CAUTION
If front riggings are used, then the seat MUST be adjusted to the highest mounting position - otherwise damage may occur.
NOTE: For this procedure, refer to FIGURE 6.1.
Installing
1.If necessary, remove the footboard. Refer to owner’s manual shipped with the wheelchair.
2.Turn front rigging to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the front rigging hinge plates with hinge pins on the wheelchair frame.
3.Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.
Telescoping Front
Rigging Support
Hinge Pins 
Front Rigging
Release Lever
Front Rigging
Hinge Plate
FIGURE 6.1 Installing/Removing Front
Riggings
4.Push the front rigging towards the inside of the wheelchair until it locks into place. NOTE: The footplate will be on the inside of the wheelchair when locked in place.
5.Repeat STEPS 1‐4 for opposite side of wheelchair.
Part No 1143195 | 17 | Van Seat |
