SECTION 11—BATTERIES
Installing/Removing Batteries Into/From Battery Boxes
WARNING
Make sure power to the wheelchair is Off before performing this procedure.
The use of rubber gloves is recommended when working with batteries.
ProBasics strongly recommends that battery installation and battery replacement ALWAYS be done by a qualified technician.
After ANY adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
NOTE: For this procedure, refer to FIGURE 11.5 on page 52.
NOTE: For changing or removing/installing the battery boxes, refer to Removing/Installing the Battery Boxes on page 49.
NOTE: To remove the battery(ies) from the battery box(es), reverse the following procedure.
NOTE: Have the following tools available:.
| TOOL | QTY | COMMENTS |
|
|
|
|
|
|
| 1 | Not Supplied |
| |
|
|
|
|
|
| 1 | Not Supplied |
| |
|
|
|
|
|
| 1 | Not Supplied |
| |
|
|
|
|
|
| Diagonal Cutters | 1 | Not Supplied |
|
|
|
|
|
|
|
|
|
|
|
WARNING
Always use the battery handle when lifting the battery. It is the most convenient method and assures that the battery acid will not spill. It also helps to prolong the life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
NOTE: If there is battery acid in the bottom or on the sides of the battery box(es) or battery(ies), apply baking soda to these areas to neutralize the battery acid. Before reinstalling the new or existing battery(ies), clean the baking soda from the battery box(es) or battery(ies).
NOTE: When securing battery lifting strap to battery, observe polarity markings located on the ends of the battery lifting strap, (+) side to POSITIVE (+) battery terminal/post and
1.If necessary, remove the battery boxes from the wheelchair. Refer to Removing/Installing the Battery Boxes on page 49.
2.Secure the battery lifting strap to battery terminal(s)/post(s).
Part No. 1123839 | 51 |
