Gas connection

I

The gas supply pipe should be connected to the gas tap (I), which is on the right next to the wiring box on the back.

It is very important to have the connections done by a qualified technician, in order to make sure that the installation is effected in accordance with the prevailing standards and instructions.

The dryer should be connected to the type of gas, which is indicated on the serial plate.

The use of too small gas pipes can result in unsufficient gas supply, which can lead to a bad heating-up and a poor drying quality.

When the dryer is used in combination with a weighing platform, the gas supply pipe has to be made of flexible material to allow the weighing system to keep moving freely.

Test all connections for possible leaks by means of a soap solution, but never with a flame.

It is important to work with the right gas pressure (see technical remarks) in order to obtain a good ignition, heating and consequently a good operation in general.

After the gas supply has been connected, the gas tap in the dryer should beturned on

(clockwise).

Page 13