Tumblers – 120 and 170
Electrical Requirements
Refer to Table 5.
NOTE: Minimum wire sizes are obtained from Canadian Electrical Code and are intended for use as a guideline only. Electrical connections should be made only by a qualified electrical contractor in accordance with all applicable local and national requirements.
NOTE: Electrical specifications below are subject to change without notice. Always refer to product
serial plate for most current specifications of product being installed.
NOTE: Use copper conductors only.
NOTE: 3 Phase Only– Each tumbler must be connected to its own individual branch circuit breaker, not fuses, to avoid the possibility of “single phasing” and causing premature failure of the motor(s).
For 120 Pound Tumbler Models
Serial Plate Rating | Terminal Block | Rated | Breaker | Breaker | Recommended | |
Connections Required | Current* | Rating | Poles | Wire Size | ||
| ||||||
|
|
|
|
|
| |
L1, L2, L3 and ground | 7.7 | 15 Amps | 3 | 14 AWG (2.08 mm2) | ||
L1, L2, L3 and ground | 3.8 | 10 Amps | 3 | 14 AWG (2.08 mm2) | ||
380V/60Hz/3ph | L1, L2, L3 and ground | 4.1 | 10 Amps | 3 | 14 AWG (2.08 mm2) | |
440V/60Hz/3ph | L1, L2, L3 and ground | 3.8 | 10 Amps | 3 | 14 AWG (2.08 mm2) | |
| L1, L2, L3 and ground | 3.9 | 10 Amps | 3 | 14 AWG (2.08 mm2) |
* Current ratings vary slightly depending on model; refer to serial plate.
For 170 Pound Tumbler Models
Serial Plate Rating | Terminal Block | Rated | Breaker | Breaker | Recommended | |
Connections Required | Current* | Rating | Poles | Wire Size | ||
| ||||||
|
|
|
|
|
| |
L1, L2, L3 and ground | 13.5 | 20 Amps | 3 | 12 AWG (3.31 mm2) | ||
L1, L2, L3 and ground | 6.9 | 15 Amps | 3 | 14 AWG (2.08 mm2) | ||
380V/60Hz/3ph | L1, L2, L3 and ground | 6.6 | 15 Amps | 3 | 14 AWG (2.08 mm2) | |
440V/60Hz/3ph | L1, L2, L3 and ground | 6.4 | 15 Amps | 3 | 14 AWG (2.08 mm2) | |
L1, L2, L3 and ground | 6.7 | 15 Amps | 3 | 14 AWG (2.08 mm2) |
* Current ratings vary slightly depending on model; refer to serial plate.
Table 5
17 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT |
