IRIS DC1100, DC1100E Mounting Flat on Wall ,

Coaxial Networks, Inc. Page 15 of 60

Mounting Flat on Wall

To mount the IRIS chassis for flat wall mount use the supplied rack mounting braces and attach

them to the holes in the middle of chassis using the same screws.

IRIS Front

Holes for Front Mounting

Holes for Rear

Mounting

Holes for Flat wall

Mounting

Figure 3 Attaching mounting braces for flat wall mount

You will need appropriate screws to secure the chassis to the wall. If you have a dry wall,

recommended screws are hollow wall anchor screws. Always check your local code for

compliance. Refer to the diagram for positioning the chassis so that sufficient air can flow in and

out of the chassis.

CHASSIS REAR

CHASSIS

FRONT

MOUNTING IRIS FLAT ON WALL

RACK MOUNT

BRACES

IRIS CHASSIS TOP

WALL ANCHOR

SCREWS, (Not

Supplied)

AIR

FLOW

AIR

FLOW

Figure 4 Flat Wall Mount

Do not mount the chassis with the chassis front of rear facing upwards. Falling debris from the

ceiling can damage the systems fans. Make sure you have sufficient room around the air ducts for

Contents

Main IRIS DC1100/DC1100E Business Class Cable Modem Termination System Installation and Operational Guide Coaxial Networks, Inc. Page Table of contents Page Table of Figures Page Copyright 2001-2005, Coaxial Networks, Inc. All rights reserved. Printed in USA Coaxial Networks, Inc. - End User Software License and Limited Warranty Software License Limited Warranty General Provisions Page Introduction Key Benefits No New Wiring Installation Requirements PC Workstation Requirement Network Service Provider Requirements Package Contents IRIS Rear Panel Connections IRIS Front Panel IRIS Mounting the IRIS Unit Mounting on standard 19 Rack with IRIS connectors in the Front Mounting Flat on Wall Page Setup Connecting Your IRIS DC1100 Checking Conditions Prior to System Startup Starting the System Configuring Your IRISDC1100 Coaxial Cable Specifications Connections Cable Network Diagram IRIS Connections with Integrated Upconverter IRIS Uplink Connection Configuration IRIS DC1100 Configuring IRIS Connecting using Web Interface Configuring TCP/IP parameters Configuring IRIS in Router mode ) Do not change the Cable CM Interface or the Cable CPE Interface address. Page Page Page Configuring Downstream RF Settings Configuring Upstream RF Settings Creating Class of Service Profiles Page Controlling Cable Modem Access ) Enabling conditional access Adding Cable Modems Saving Cable Modems List Page Page Page Coaxial Networks, Inc. Page 37 of 60 Figure 21 List of CLI commands preg or preg verbose command psid command pcpe command config_cm command count command Page upcon command Page Page Application Notes Network traffic between cable clients Allowing PPPoE traffic across IRIS Static IP Mapping Page Channel Frequency Chart NTSC Channel Frequency Chart in MHz (DOCSIS) Page Page Page Coaxial Networks, Inc. Page 49 of 60 PAL Frequency Allocation (EuroDOCSIS) Table 1Channel Center Frequencies for Selected PAL Systems Coaxial Networks, Inc. Page 50 of 60 Table 2 Channel Center Frequencies for System G Hyperband Page Regulatory Compliance Agency Standards Specifications VI (Visual) Editor Entering the vi Insert/Overtype Mode Command Mode Entering Insert Mode Page Miscellaneous ex Commands ex syntax The vi environment variables File Saving and Loading Examples