SP5BT | User Manual |
OPERATION
To turn the headset ON:
►Hold the multifunction button for 3 seconds.
●A tone is heard and a blue LED rapidly flashes 5 times.
●After releasing the multifunction button the blue LED blinks every few seconds indicating that the unit is in standby mode.
NOTE: If the LED slowly flashes red, the headset battery is low. You should recharge the headset as soon as possible to prevent loss of power. Please refer to Charging section on page 11.
It is a good idea to turn the headset off when you are not using it to conserve battery power.
To turn the headset OFF:
►Hold the multifunction button for 3 seconds.
●A tone is heard and a red LED rapidly flashes 5 times.
●The headset is powered off.
The headset may become disconnected from your mobile phone when either device is powered off, or if the phone moves out of range.
To reconnect to your mobile phone (after initial pairing)
►Briefly press and release the multifunction button.
●The headset establishes a connection with the phone.
●A confirmation tone is heard.
●Voice dialing is activated. You may cancel voice dialing by pressing the multifunction button again.
To answer an incoming call
►Press the multifunction button briefly and release. Call is answered.
►Press the button again to end the call.
To reject an incoming call
►Hold the multifunction button for 2 seconds. Call is rejected.
