Ives 232TGSL manual Assembly of the Impact Wrench

Maintenance Section (Continued)

1.Coat Hammers (33) with a light film of Ingersoll-Rand No. 100 Grease.

2.Replace Hammers in Hammer Frame (30) exactly as they were when you marked them prior

If you are installing new Hammers or want to change the location of the existing Hammers to utilize both impacting surfaces, slide the Hammers in the Hammer Frame so that the half-round notch on one Hammer is located on one side of the Frame and the half-round notch on the other Hammer is located on the other side of the Frame.

3.Replace Hammer Pins (31).

4.Examine base of Anvil (40) and note its contour. While looking down through the

Assembly of the Impact Wrench

1.Set assembled impact mechanism down over splined hub of Rotor.

2.Smear a thin film of Ingersoll-Rand No. 100 Grease on inside surface of Hammer Case

3.Install Hammer Case Cap Screws (38). Tighten Hammer Case Cap Screws to 60 to 70 in-lb.

16