SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
CHEMICAL DISPENSING EQUIPMENT
WARNING:
This equipment is not recommend for use with deionized water or other aggressive fluids. Use of deionized water or other aggressive fluids will result in corrosion and failure of materials and components. Use of deionized water or other aggressive fluids will void the manufacturer's warranty.
TO PREPARE CHEMICAL FEEDER PUMPS FOR OPERATION
The Avenger™HT dishmachine is supplied with integral detergent and rinse aid chemical feeder pumps. The Avenger™LT dish- machine is supplied with integral detergent, rinse additive and sanitizer chemical feeder pumps. Locate the open ends of the chemical tubes with the tube stiffeners and place each one in the appropriate container.
A.Red Tubing = Detergent
B.Blue Tubing = Rinse Aid
C.White Tubing = Sanitizer
PRIMING CHEMICAL FEEDER PUMPS
Chemical feeder pumps need priming when the machine is first installed or if for some reason the chemical lines have been removed and air is allowed to enter.
CAUTION: Water must be in the sump and wash tank prior to the dispensing of chemicals. Sanitizer in concentration is caustic and may cause damage without dilution.
1.Verify that the proper chemical tube stiffener inlet is in the proper container.
2.Use the prime switches located on the control panel at the bottom of the unit to prime each pump. The switches are clear- ly marked as to what chemical feeder pump they are assigned to.
3.To prime the pumps, hold the switch in the momentary position until chemical can be observed entering the sump.
4.Detergent is dispensed as required during the wash cycle by the cam timer. The amount of detergent may need to be increased or decreased depending on water quality and type of detergent.
5.Rinse additive is dispensed as required into the final rinse. The amount of rinse aid may need to be adjusted depending on water hardness and results.
6.Sanitizer (either chlorine or iodine) is dispensed into the final rinse. The amount of sanitizer may need to be adjusted depending on the concentration and type of sanitizer used.
7.Please refer to the next page for instruction on adjusting the chemical feeder pumps on the universal timer.
WARNING: Some of the chemicals used in dishwashing may cause chemical burns if they come in contact with your skin. Wear protective gear when handling these chemicals. If you do come in contact with these chemi- cals, immediately flush the affected area with fresh water.
Avenger™ Series Technical Manual
Issued:
9