SECTION 1: SPECIFICATION INFORMATION
SPECIFICATIONS of the AVENGER™HT
PERFORMANCE/CAPABILITIES
OPERATING CAPACITY (RACKS/HOUR)
RACKS PER HOUR
DISHES PER HOUR
GLASSES PER HOUR
OPERATING CYCLE (SECONDS)
WASH TIME
DRAIN TIME
RINSE TIME
TOTAL CYCLE TIME (MINUTES)
ELECTRICAL REQUIREMENTS
WASH MOTOR HP | 3/4 |
30
NOTE: Typical Electrical Circuit is based upon (1) 125% of the
600full amperage load of the machine and (2) typical
600cuit breaker sizes as listed in the NEC 2002 Edition. Local codes may require more stringent protection than what is dis-
| played here. Always verify with your electrical service con- |
| tractor that your circuit protection is adequate and meets all |
| applicable national and local codes. These numbers are pro- |
82 | vided in this manual simply for reference and may change |
28 | without notice at any given time. |
| |
10 | Avenger™HT: |
2 |
|
|
|
| RINSE |
| TYPICAL |
|
|
| HEATER | TOTAL | ELECTRICAL |
5 MINUTE TIMER OPERATING CYCLE (SECONDS) | VOLTS PH | HZ | RATINGS | AMPS | CIRCUIT |
|
|
|
|
|
WASH TIME
DRAIN TIME
RINSE TIME
TOTAL CYCLE TIME (MINUTES)
TANK CAPACITY (LITERS) (GALLONS)
262 | 208 | 1 | 60 | 8.2KW @ 230V | 39 A | 50 AMP | |
230 | 1 | 60 | 8.2KW @ 230V | 42 A | 60 AMP | ||
| |||||||
28 |
|
|
|
|
|
| |
10 | NOTE: Always refer to the machine data plate for specific | ||||||
| electrical and water requirements. The material provided on |
5 | this page is for reference only and may be subject to change |
| |
| without notice. |
WASH TANK | (4.2) 1.1 | |
RINSE TANK | (11.4) | 3 |
TEMPERATURES |
|
|
(65.6°C) | 150°F | |
(82.2°C) 180°F | ||
WATER REQUIREMENTS |
|
|
INLET TEMPERATURE (MINIMUM)* | (43.3°C) 110°F | |
INLET TEMPERATURE (RECOMMENDED) | (60°C) 140°F | |
WATER LINE SIZE I.P.S. (MINIMUM) |
| 1/2” |
DRAIN LINE SIZE I.P.S. (MINIMUM) |
| 1 1/2” |
FLOW PRESSURE P.S.I. |
| 20 ±5 |
*In some cases, this may automatically extend the wash cycle time.
Avenger™ Series Technical Manual
Issued:
2