Jackson Avenger HT SPECIFICATIONS of the AVENGERLT, Operating Cycle Seconds Wash Time, AvengerLT

SECTION 1: SPECIFICATION INFORMATION

SPECIFICATIONS of the AVENGER™LT

PERFORMANCE/CAPABILITIES

OPERATING CAPACITY (RACKS/HOUR)

RACKS PER HOUR

DISHES PER HOUR

GLASSES PER HOUR

OPERATING CYCLE (SECONDS) WASH TIME

DRAIN TIME

RINSE TIME

TOTAL CYCLE TIME

TEMPERATURES

ELECTRICAL REQUIREMENTS

WASH MOTOR HP 3/4

24

NOTE: Typical Electrical Circuit is based upon (1) 125% of the

600full amperage load of the machine and (2) typical fixed-trip cir-

600cuit breaker sizes as listed in the NEC 2002 Edition. Local

codes may require more stringent protection than what is dis- played here. Always verify with your electrical service con- tractor that your circuit protection is adequate and meets all applicable national and local codes. These numbers are pro-

56	vided in this manual simply for reference and may change
26	without notice at any given time.
35

120	Avenger™LT:
			RINSE		TYPICAL
			HEATER	TOTAL	ELECTRICAL
	VOLTS PH	HZ	RATINGS	AMPS	CIRCUIT

WASH ---	(MINIMUM)	(48.9°C) 120°F
WASH ---	(RECOMMENDED)	(60°C) 140°F
RINSE ---	(MINIMUM)	(48.9°C) 120°F
RINSE ---	(RECOMMENDED)	(60°C) 140°F
WATER REQUIREMENTS
INLET TEMPERATURE (RECOMMENDED)		(60°C) 140°F
INLET TEMPERATURE (MINIMUM)		(48.9°C) 120°F
WATER LINE SIZE I.P.S. (MINIMUM)		1/2”
DRAIN LINE SIZE I.P.S. (MINIMUM)		1 1/2”
FLOW PRESSURE P.S.I.		20 ±5
MINIMUM CHLORINE REQUIRED (PPM)		50

115 1 60 N/A 14 A 20 AMP

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.

Avenger™ Series Technical Manual 7610-003-34-01 Rev. A

Issued: 05-02-2007 Revised: N/A

3