Jackson JPX-200 SPECIFICATIONS of the JPX-160, Operating Cycle Seconds Wash Time, Temperatures

SPECIFICATIONS of the JPX-160

PERFORMANCE/CAPABILITIES

OPERATING CAPACITY (RACKS/HOUR)

RACKS PER HOUR

DISHES PER HOUR

GLASSES PER HOUR

OPERATING CYCLE (SECONDS) WASH TIME

JRINSE TIME

PTOTAL CYCLE TIME

X

1TANK CAPACITY (GALLONS)

ELECTRICAL REQUIREMENTS

WASH PUMP MOTOR HORSEPOWER 1/2

24NOTE: Typical Electrical Circuit is based upon (1) 125% of the

192full amperage load of the machine and (2) typical fixed-trip circuit breaker sizes as listed in the NEC 2002 Edition. Local

600codes may require more stringent protection than what is displayed here. Always verify with your electrical service contractor that your circuit protection is adequate and meets all applicable national and local codes. These numbers are

107	provided in this manual simply for reference and may change
	without notice at any given time.
14
121				RINSE		TYPICAL
				HEATER	TOTAL	ELECTRICAL
	VOLTS	PH	HZ	RATINGS	AMPS	CIRCUIT
	208	1	60	2.7 KW@208V	24	30 AMP
	230	1	60	3.3 KW@230V	26	35 AMP

6

0

WASH TANK (MINIMUM)

RINSE TANK

3.4

1.4WATER REQUIREMENTS

TEMPERATURES

WASH---°F (MINIMUM)

RINSE---°F

	INLET TEMPERATURE	140°F
	GALLONS PER RACK	.59
150	GALLONS PER HOUR	14.2
180	WATER LINE SIZE I.P.S. (Minimum)	1/2”
	DRAIN LINE SIZE I.D.	1”
	FLOW PRESSURE P.S.I.	20 A5
	FRAME DIMENSIONS
	WIDTH	19”
	DEPTH	20”
	HEIGHT	29 5/8”
	MAXIMUM INSIDE CLEARANCE	14”

NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.

This equipment is not recommend for use with deionized water or other aggressive fluids. Use of deionized water or other aggressive fluids will result in corrosion and failure of materials and components. Use of deionized water or other aggressive fluids will void the manufacturer's warranty.

21