SPECIFICATIONS of the JPX-200
J P X
2
0
0
PERFORMANCE/CAPABILITIES
OPERATING CAPACITY (RACKS/HOUR)
RACKS PER HOUR
DISHES PER HOUR
GLASSES PER HOUR
OPERATING CYCLE (SECONDS)
SHORT CYCLE
WASH TIME
RINSE TIME
TOTAL CYCLE TIME
LONG CYCLE
WASH TIME
RINSE TIME
TOTAL CYCLE TIME
TANK CAPACITY (GALLONS)
WASH TANK (MINIMUM)
RINSE TANK
TEMPERATURES
ELECTRICAL REQUIREMENTS
WASH PUMP MOTOR HORSEPOWER | 1 |
24
NOTE: Typical Electrical Circuit is based upon (1) 125% of the
600full amperage load of the machine and (2) typical
600circuit breaker sizes as listed in the NEC 2002 Edition. Local codes may require more stringent protection than what is displayed here. Always verify with your electrical service
contractor that your circuit protection is adequate and meets all applicable national and local codes. These numbers are provided in this manual simply for reference and may change
105 | without notice at any given time. |
|
| |||
|
|
|
|
|
| |
15 |
|
|
| RINSE |
| TYPICAL |
120 |
|
|
| HEATER | TOTAL | ELECTRICAL |
VOLTS | PH | HZ | RATINGS | AMPS | CIRCUIT | |
| 208 | 1 | 60 | 6 KW@208V | 45 | 60 AMP |
| 230 | 1 | 60 | 7.3 KW@230V | 48 | 60 AMP |
225 | WATER REQUIREMENTS |
|
| |||
|
|
| ||||
15 | INLET TEMPERATURE |
| 140°F | |||
240 |
| |||||
GALLONS PER RACK |
| .98 | ||||
|
| |||||
| GALLONS PER HOUR |
| 23.5 | |||
8.7 | WATER LINE SIZE I.P.S. (Minimum) | 1/2” | ||||
DRAIN LINE SIZE I.D. |
| 1” | ||||
|
| |||||
2.1 | FLOW PRESSURE P.S.I. |
| 20 A5 | |||
|
| |||||
| FRAME DIMENSIONS |
|
| |||
150 | WIDTH |
|
|
| 23” | |
180 |
|
|
| |||
DEPTH |
|
|
| 23 3/4” | ||
|
|
|
| |||
| HEIGHT |
|
|
| 32 1/4” | |
| MAXIMUM INSIDE CLEARANCE | 14” |
NOTE: Always refer to the machine data plate for specific electrical and water requirements. The material provided on this page is for reference only and may be subject to change without notice.
This equipment is not recommend for use with deionized water or other aggressive fluids. Use of deionized water or other aggressive fluids will result in corrosion and failure of materials and components. Use of deionized water or other aggressive fluids will void the manufacturer's warranty.
35