Jacuzzi GQ99000 manual Control Panel, Chromatherapy Lamp, Page of

CAUTION: The panel and lamp(s) require modular cables from behind. Make sure the proposed location of the panel and lamp(s) will not cause cables to interfere with the bath plumbing

The control panel and each lamp must be mounted on a minimum flat surface space of the bath shell, see Table 1, Mounting Surface Requirements.

Table 1. Mounting Surface Requiements

EQUIPMENT FLAT MOUNTING SURFACE

------------------------------------------------------------------------

Control panel	3 x 2 inches
Lamp (each)	2-1/2 by 2-1/2 inches

Next, consider the following cable lengths, starting with the control box. See Table 2, Cable Lengths.

Table 2. Cable Lengths

CABLELENGTH

--------------------------------------------------------

Control box cable	32 inches
Control panel cable	72 inches (6 feet)
Chromatheraphy lamp	84 inches (7 feet)

The control box must be mounted on a stud beam or secure wall within 32 inches of the GFCI power outlet. The outlet must be a minimum of 4 inches above the floor. In addition it must be located no further than the length that the modular control cable or any lamp cable may extend.

Once the location of the control box has been determined, you may determine the location of the control panel and the lamp(s), and prepare to drill a hole for each item.

Control Panel

Before marking the inside of the bath shell, place masking tape over the entre area of the proposed hole. The tape will help prevent chipping of the acrylic.

Writing on the tape, use a pointed marker to indicate the outline of the hole for the control panel, see Figure 3. The control panel is

2-1/2 by 1-1/2 inches and requires a minimum of 3 by 2 inch flat mounting surface. Carefully mark the center of the hole.

Also mark the 5/32 inch notch at the right side of the diameter, and mark the center of the notch. It is critical to measure the hole and notch precisely.

Chromatherapy Lamp

Use a marker to indicate on the inside of the bath shell where the lamp(s) will be located

CAUTION: Before marking the inside of the bath shell, place masking tape over the entire area of the proposed hole, to help prevent chipping of the acrylic.

Use a marker to indicate the location of the Chromatheraphy lamp(s). The lamp is 2 inch diamerter and requires a minimum of 2-1/2 diameter flat mounting surface. (Locate as many lamps as are intended for installation.) Indicate a hole for 1-5/8 inch diameter, see Figure 4.

Jacuzzi© Chromatherapy: Installation and Operation Page of 5

1-1/16 inch 5/32 inch

DETAIL

1/2 inch

Figure 3. Hole for Control Panel

1-5/8 inch

Figure 4. Hole for Chromatherapy Lamp(s)

GQ99000 • 07-08

Lens cable (1-4)