English
Comfort PLUS Whirlpool Bath
Inspection and Testing
Visual Inspection
1Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only.
2Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visible damage to any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub is installed is excluded from the warranty. Jacuzzi Luxury Bath’s responsibility for shipping damage ceases upon delivery of the products in good order to the carrier.
3Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty information packed with the product or in the back of this manual.
Bathtub Water and Operational Test
All bathtub units are factory tested for proper operation and watertight connections prior to shipping. However, the unit must be retested by the installer prior to installation. Jacuzzi Luxury Bath is not responsible for any defect that could have been discovered, repaired, or avoided by following this inspection and testing procedure:
1Place the bathtub on a level surface, near appropriate electrical supply, water supply, and water drainage. A driveway is a suitable choice.
2Seal the drain and overflow hole with tape or a stopper and fill the bathtub to the bottom of the overflow hole.
3Allow bathtub to stand for 5 minutes.
4Plug in motor/pump and turn unit on. Confirm that all features function as described in the Operation section of this manual. Do not install the bathtub if bathtub fails to operate as described.
5Visually inspect all joints for leaks. Do not install the bathtub if leaks are detected.
6Return bathtub to box or otherwise protect from damage until time of installation.
Framing and Support
A technical specifications manual has been included with your bathtub. The Technical Specifications Manual will contain pertinent information regarding your Jacuzzi Luxury Bath product. Locate the Technical Specifications Manual at this time.
Frame out the space where the bathtub is to be located. The following should be taken into consideration when preparing the area:
• Dimensions provided on
• The floor structure beneath the bathtub must be able to support the total weight of the bathtub, water and bather.
• The unit must be supported from the bottom of the bathtub and not from the bathtub rim. For
• The rim of the bath is not designed to support weight. If finish material is to overlap or contact the bath, the added weight must be fully
• Ensure the rim will rest on a level surface.
• Per code, access must be provided to the motor/pump for your specific model. Primary and secondary service access locations are shown in the
Figure 1
It is the responsibility of the installer, building contractor, or owner to provide access for service. Jacuzzi is not responsible for any costs relating to obtaining access for repair. The owner shall bear such costs and, if appropriate, must seek recovery from the installer.
•Provide adequate ventilation for cooling and supply sufficient air for the motor/pump. Do not insulate around the equipment.
•Your bathtub may have motor/pump parts that extend beyond the rim of the bathtub. Refer to the
Page 8 | www.jacuzzi.com | Installation and Operation |
