English
Comfort PLUS Whirlpool Bath
Drop-in Installation (con’t)
10Inspect all fittings, plumbing, and control lines after inserting to insure the components are not damaged, disconnected, or contacting the finish surface substrate or support members.
11 | Align the bathtub and connect the drain. |
12 | Turn on the power supply to the dedicated GFCI |
| protected circuits and check system operation. |
13 | Caulk around the perimeter of bathtub to seal the |
| space between the rim and the finished deck. |
Figure 7
3-Wall Alcove Installation
1Install the drain/overflow according to the manufacturer’s instructions. Refer also to the Technical Specifications Manual.
Watertight installation of the drain is the installer’s responsibility. Drain leakage is excluded from the Jacuzzi Luxury Bath warranty of this product.
2Install the faucet at this time. It is recommended that the faucet be installed by a qualified plumber.
3Install the flange (purchased separately) according to the instructions that are included with the kit. If the bathtub is equipped with an integrated flange, skip this step.
4Turn off the power supply to the GFCI protected circuit.
5Insulation may be placed within the bathtub surround, except around the motor/pump.
6Connect flex water supply lines to faucet and plug power cords into GFCI outlet.
7Place the bathtub into the niche. Screw the flange to the wood stud. It may be necessary to shim the unit to close up any gaps between the wood stud and the flange.
8Align the bathtub and connect the drain.
9Inspect all fittings, plumbing, and control lines after inserting the bathtub to insure the components are not damaged, disconnected, or contacting the finish surface substrate or support members.
10Turn on the power supply to the dedicated GFCI protected circuits and check system operation.
11Complete all finish work around the perimeter of bathtub to seal the space between the rim and the finished deck.
| Cement Board |
| Mortar |
| Finishing |
| Material |
| Plastic Filler |
| Silicon/Sealant |
Screw | Bath Rim |
| Tile Flange |
| Stud Wall |
| 1˝ x 4˝ (not for |
| support) |
Figure 8
Tile
Stud Wall
Cement Board
Tile Adhesive
Caulking
Mounting
Screw
Tile Flange
Stud
1˝ x 4˝ (not for support)
Figure 9
Page 12 | www.jacuzzi.com | Installation and Operation |
