M1102/M1103
OPERATIONS
General
The Model M1102/M1103 will perform many types of operations that are beyond the scope of this manual. Many of these operations can be dangerous or deadly if performed incorrectly.
The instructions in this section are written with the understanding that the operator has the necessary knowledge and skills to operate this machine. If at any time you are experiencing difficulties performing any operation, stop using the machine!
If you are an inexperienced operator, we strongly rec- ommend that you read books, trade articles, or seek training from an experienced Drill Press Operator before performing any unfamiliar operations. Above all, your safety should come first!
READ and understand this entire instruc- tion manual before using this machine. Serious personal injury may occur if safety and operational information is not understood and followed. DO NOT risk your safety by not reading!
OPERATIONS
Installing & Removing
Drill Bits
Any drill bit you install in the chuck must be tight enough that it will not come loose during operation.
To install a drill bit, do these steps:
1.DISCONNECT THE DRILL PRESS FROM POWER!
2.Using the chuck key, open the drill chuck wide enough to accept the shank of the drill bit.
3.Insert the drill bit as far as possible into the chuck WITHOUT allowing the chuck jaws to touch the fluted portion of the bit, and hand tighten the chuck. Note: Make sure small bits are not trapped between the edges of two jaws; if they are, rein- stall the drill bit or it will not be secure enough to use for drilling.
4.Final tighten the drill bit with the chuck key.
To remove a drill bit, do these steps:
1.DISCONNECT THE DRILL PRESS FROM POWER!
2.Use the chuck key to open the drill chuck, and catch the drill bit with a rag to protect your hands.
Always wear safety glasses when oper- ating the Drill Press. Failure to comply may result in serious personal injury.
DO NOT investigate problems or adjust the Drill Press while it is running. Wait until the machine is turned OFF, unplugged and all working parts have come to a complete stop before proceeding!
