Label Placement and Parts, REF PART# Description | Woodstock M1102

M1102/M1103 16-Speed Drill Press

Label Placement and Parts

Safety labels warn about machine hazards and how to prevent machine damage or injury. The owner of this machine MUST maintain the original location and readability of all labels on this machine. If any label is removed or becomes unreadable, REPLACE that label before allowing the machine to enter service again. Contact Woodstock International, Inc. at (360) 734-3482 or www. shopfoxtools.com to order new labels.

91

94

92

93

95

96

97

REF PART�# DESCRIPTION

191	XLABEL01H	SAFETY�GLASSES�LABEL
192	XLABEL03	CLOSE�COVER�LABEL
193	XM1102193	MACHINE�DATA�LABEL�(M1102)
193	XM1103193	MACHINE�DATA�LABEL�(M1103)
194	XM1102194	SHOP�FOX�LOGO�PLATE
195	XLABEL04S	ELECTRICAL�LABEL
196	XM1102196	MOTOR�DATA�LABEL
197	XM1102197	BELT�SPEEDS�LABEL

PARTS

-37-

Image 39

Woodstock M1102, M1103 owner manual Label Placement and Parts, REF PART# Description

Contents

Speed Drill Press Page Contents Service Introduction Woodstock Technical SupportAbout Your New 16-Speed Drill Press M1103 Specifications M1102 Specifications Cast Iron Base with T-Nut Slots Allows for maxi Identification Safety Safety Instructions for MachineryBefore Operating this Machine Always Lock Mobile Bases if Used Before Operating Machinery Safety for Drill Presses Grounding Electrical110V Operation Extension Cords SET UP UnpackingInventory Cleaning Machine Machine Placement To secure the column to the base, do these steps To install the table supportColumn and Base Table Support Sliding table support and rack Over the column Aligning headstock with a Typical drill press base Headstock To install the chuck guard, do these steps Chuck GuardDrill Chuck & Arbor Seating arbor into chuck To install the downfeed handles, do these steps To install the table, do these stepsDownfeed Handles & Belt Cover Knob Work Light Test RunTo test run the drill press To mount the Model M1102 drill press to a table Mounting General Installing & Removing Drill BitsTo install a drill bit, do these steps Operations To change spindle RPM, do these steps Changing Spindle RPM To tilt the table, do these steps Adjusting Table TiltDepth Stop To set the depth stop, do these steps Operations Operations To remove the drill chuck and arbor, do these steps Arbor Removal Lubrication MaintenanceBelts Table and Base Troubleshooting Service M1102/M1103 16-Speed Drill Press Drill Press Operations Feed Shaft Spring Tension Capacitor Electrical Components Parts 110V Wiring Diagram M1102/M1103Wiring Diagram Service Notes M1102/M1103 Parts Diagram PART# Description M1102/M1103 Parts List Wiringharness REF PART# Description Label Placement and Parts Parts Notes Warranty Comments Warranty Registration BOX BELLINGHAM, WA