Jasco RM24922 instruction manual Code Search, Code Identification

Code Search

If your device does not respond after you have tried all the codes for your brand, or if your brand is not listed, try searching for your code by following these steps.

1.Manually turn on the device (TV, VCR, etc.) to be controlled.

2. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.

3.Press and quickly release the desired mode button (TV, VCR, etc.). The red indicator blinks off once.

4. Press the CHANNEL UP button repeatedly (up to 300 times) until

the device to be controlled changes channel. The red indicator blinks off with each

button press. If you accidentally overshoot the code required, press the CHANNEL DOWN button to backtrack through the library until the device changes channel. Pressing CHANNEL UP changes direction to forward again.

5.Press and release ENTER to install the code.

Most users will store VCR codes under the VCR button, Cable codes under CABLE, etc. If (for example) you want to store a VCR code under CABLE, first follow the procedure for Direct Code Entry (page 8) and press CABLE in step 2 of Direct Code Entry, then enter ANY VCR code in step 3 of Direct Code Entry. Then follow the steps above for Code Search.

Note: If the device does not have a CHANNEL UP button, use PLAY (VCR only) or POWER instead. Code Search starts from the currently stored three digit number under that mode. Sometimes the first code that “works” with your device may only allow limited functionality (e.g. the MENU button might not work). There may be a code that performs more functions. Continue the code search process until the best code

is found. 8

Code Identification

The Code Identification Feature allows you to identify the 4 digit library code stored under your device key. For example, if you want to find out what 4 digit code is stored under your TV device key, follow the six steps below:

1. Press and hold the SETUP button until the red indicator stays on. Release the SETUP button.

2. Press and release the desired mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.

3. Press and release the SETUP button. The red indicator blinks once and remains lit.

4. To find the first digit for the code stored under the mode key pressed in step 2, press each numeric key from 0-9in turn. The number that causes the indicator light to blink is the first digit in your code.

5.To find the second digit, repeat step 4.

6.Repeat step 4 again to find the third and fourth digits. This time the red indicator turns off and stays off.

9