![](/images/new-backgrounds/1316599/3165995x1.webp)
TWEETER INSTALLATION
English
SURFACE-MOUNT
Figure 4. Surface-mounting the tweeter and connecting the crossover.
BLACK
RED (+)
1
2
BLACK
(–)SMALL LUG
BLACK
RED (+)
RED
(+) LARGE LUG
Figures 7A through 7D. The Starfish™ | Figure 7B. |
tweeter mount is intended to be used | behind grille panel. |
when the tweeter will be installed behind a |
|
factory grille (e.g., replacing the factory |
|
tweeter behind a door panel). The Starfish |
|
will allow you to mount the component |
|
tweeter directly to the panel itself or to the |
|
area behind the panel. The six mounting |
|
tabs can be removed easily to create a |
|
number of custom configurations. |
|
Note: Check screw clearance before |
|
installing. Use glue if clearance is an issue. | Figure 7C. Mounted to grille panel. |
|
FLUSH-MOUNT
Figure 5. Mounting the tweeter using the I-Mount™ (patent no. 5,859,917) flush-mounting kit.
3
1
2
TWEETER ANGLE
Figure 6. Aim the tweeter at the listening position by sliding the screw in the groove on the back of the tweeter cup and lock the tweeter in place using the small retain- ing screw. Rotate the entire assembly in the mounting surface and tighten the large hand nut.
3
ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.
1
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
2
TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.
4
SECURELY TIGHTEN
THE LARGE HAND NUT.
Note: Not all possible mounting configurations are shown.
Figure 7A. Surface-mounted behind grille panel.
Figure 7D. In-dash location (may require gluing).
3