JBL INVADER manual Specifications, Regulatory

	Check the speaker control	Set each of the two knobs
	settings.	(treble, bass level) on front
		of the subwoofer back the
		their center /nominal
		positions.
Too much bass or treble.	Bass/Treble level is set too	Turn Bass/Treble down or
	high	return their settings to the
		center position.
Subwoofer emits a loud	Input cables not plugged in	Check input cable
hum or buzzing noise.	properly	connection
Speaker system	Input cable may be picking	Wrap up excess input
experiences radio	up interference	cable in order to make as
frequency interference or		short as possible
picks up a radio station		Purchase a ferrite clamp
		and attach over input
		cable. A clamp can be
		purchased at your local
		electronics store

SPECIFICATIONS

Manufacturer	Harman Multimedia
Model	JBL INVADER
Drivers (satellite)	Phoenix SE
Drivers (subwoofer)	One 6 inch Magnum woofer
Power (satellite)	12 watts per satellite at 1% THD
Power (subwoofer)	32 watts at 1% THD
Crossover Frequency (subwoofer)	150 Hz
Dimensions
Width:
Satellite	3.0 inches	75mm
Subwoofer	7.5 inches	190mm
Depth:
Satellite	4.0 inches	100mm
Subwoofer	9.0 inches	225mm
Height:
Satellite	9.5 inches	240mm
Subwoofer	12 inches	300mm
Input Impedance	>5k Ohm
Signal-to-Noise ratio	>85dB
Frequency Response	40 – 20 kHz
Input Sensitivity	400 mV rms for rated power output
USA/Canada Power	120 volts, 60Hz AC
Maximum Power Consumption	120 watts
UL/CUL/CE Approved

Regulatory

FCC Statement and Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

a)Re-orient or relocate the receiving antenna.

b)Increase the separation between the equipment and receiver.

c)Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

d)Consult the dealer or an experienced radio/TV technician for help.

MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.

Document Number: 950-0042	Description: MANUAL, JBL 4.1, All languages
Revision: 06