Pairing
By default, all JBL on stageTM* II systems work on the same "RF channel." If more than one JBL on stageTM* II Remote control is within range of the speaker unit, multiple remotes would be able to control the speaker unit. If this is not desirable, the speaker unit must be paired with a unique remote. Pairing allows only one remote to control the speaker unit.
To Turn Pairing On
Press the Pairing switch on the bottom of the
JBL on stageTM* II unit by inserting a paper clip or similar device. Then press any button on the Remote within 5 seconds to associate that particular remote with the unit.
To Turn Pairing Off
Press the Pairing switch on the bottom of the
JBL on stageTM* II unit by inserting a paper clip or similar device. Hold the paper clip or similar device for about 5 seconds. DO NOT press any buttons on the Remote Control. After about 5 seconds, the unit will respond to any JBL on stageTM* II remote control.
Pairing Button
Troubleshooting
If JBL on stageTM* II is not responding to the remote's commands, check for the following possible problems and solutions.
Possible Problem | Solution |
No power to the | Ensure that the correct power supply is |
system | connected to JBL on stageTM* II. Ensure |
| that the power button is pushed inward |
| and the green LED is lighted. |
Remote switch in a | Ensure the side Hold switch is in the |
lock position | position that prevents the orange dot |
| from being visible. |
iPod® player does not Turn the JBL on stageTM* II off and
recognize the undock the iPod® player. Wait for 30 remote's commands seconds. Dock the iPod® again and
turn the JBL on stageTM* II on.
Remote Control Technical Specifications
-Transmission: Radio Frequency
-Frequency: 433.92 MHz
-Operating Range: Up to 20 ft.
-Battery: CR2032 3V
-Dimensions:
-Weight (Including Battery): 0.8 oz.
Battery Replacement
The JBL on stageTM* II remote's battery should last a year under normal usage. To replace the battery, open the remote control unit by removing the three small screws in the back of the remote, and replace the old battery with a CR2032 type battery or equivalent.
Thesespecifications aresubjectto changewithout notice. | 9 |
|
