three. Operation
Mode | Procedure | LED Status |
Off | Receiver/amplifier off | Off |
|
|
|
On | Receiver/amplifier on and playing program material | Green |
|
|
|
Auto | Simply turn off your receiver/amplifier. The speaker will | Red |
| turn off after approximately five minutes. The speaker |
|
| will turn on when your receiver/amplifier begins playing again. |
|
|
|
|
Level
The level control adjusts the volume of the subwoofer in relation to the system’s overall volume.
0 | 10 | 0 | 10 |
| Level |
| Level |
Troubleshooting
If there is no sound from any of the speakers, check the following:
•Receiver/amplifier is on and a source is playing.
•Review proper operation of your receiver/amplifier.
If there is no sound coming from one speaker, check the following:
•Check the “Balance” control on your receiver/amplifier.
•Check all wires and connec- tions between receiver/ amplifier and speakers.
•Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.
If the system plays at low volumes but shuts off as volume is increased, check the following:
•Check all wires and connections between receiver/ amplifier and speakers.
•Make sure all wires are con- nected. Make sure none of the speaker wires are frayed, cut or punctured.
•If more than one pair of main speakers is being used, check the minimum imped- ance requirements of your receiver/amplifier.
If you used the
•Receiver/amplifier is on and a source is playing.
•TLX271P is plugged in.
•Check all wires and connec- tions between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the speaker wires are frayed, cut or punctured.
•Review proper operation
of your receiver/amplifier.
If there is low bass output, check the following:
•Make sure the connections to the left and right “Speaker Inputs” have the correct polarity (+ and
•Make sure that the TLX271P is plugged into an active electrical outlet.
If you used the
•Receiver/amplifier is on and a source is playing.
•TLX271P is plugged in.
•Check all wires and con- nections between receiver/ amplifier and speakers. Make sure all wires are connected. Make sure none of the wires are frayed, cut or punctured.
•Review proper operation of your receiver/amplifier.