Jeep 50-0284x-015 Series installation instructions

10.Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to C-pillar. Down the C-pillar to the floor. Route the power lead to an accessory controlled source. Connect the ground lead to the vehicle chassis. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc.) to the VCP location. See Figure 6. Connect per instructions included with the video system. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna.

FIGURE 6

II. INSTALLATION OF CONSOLE

IF SPEAKER UPGRADE KIT WAS PURCHASED, INSTALL PER INSTRUCTIONS PROVIDED.

11. Raise console (item 8 pg.2) into approximate position against headliner. Loosely install using

(2) two 6-32 x 3/4" screws (item 2 pg. 2) through the smaller holes in bracket on console into threaded clips on front mounting bracket. See Figure 7.

12. Using a scribe or similar tool, align hole in rear of console with slot in rear mounting bracket. Loosely secure rear of console using (1) one # 8 x 1 1/2" screw (item 4 pg. 2). Make sure console alignment is straight then tighten (2) two 6-32 screws previously installed. See Figure 7.

FIGURE 7

5